How to install your JDM stickers or decals.

Step 1: Clean

Wipe clean the window or surface you are applying the decal to with rubbing alcohol & Allow to dry.

Step 2: Press decal to insure adhesion to transfer tape.

Lay the decal down and rub over the graphic with a squeegee or credit card. This is important to make sure all parts of the sticker are stuck to the transfer tape!

Step 3: Peel Transfer tape with decal.

Carefully peel off the white backing layer or the thicker plastic layer from the decal. Only the vinyl and the clear or paper like transfer layer should remain. If any part of the graphic clings to the backing layer, Lay that part down and use your finger to press it back to adhere to the transfer tape. Peel the backing off again.

Step 4: Apply.

Place your decal. on the surface. Use a credit card or squeegee to rub and smooth the decal onto the window or surface desired. Work from the center of the decal to the outside.

Step 5: Remove transfer tape to reveal your custom sticker/decal.

Remove the clear transfer layer by peeling it off starting from the corner. Only the vinyl (Sticker/Decal) should remain on the surface! Enjoy your new custom decals!